Goldpoint Attenuator with Phono Preamp

Discussion in 'General Audio Discussion' started by Goldenears, Feb 25, 2022.

Thread Status:
Not open for further replies.
  1. Goldenears

    Goldenears New

    Joined:
    Feb 25, 2022
    Likes Received:
    0
    Trophy Points:
    1
    Location:
    80907
    Hi, I am new here and have been reading about the Goldpoint Passive Attenuators! Wondering if this would work well with my devices! Especially an outboard phono section! It would be running Balanced Out of the phono preamp to the Goldpoint Input! Then the Goldpoint would run from Output XLR to RC 35 device Input also XLR! Then RC 35 XLR to Balanced Amps! There is a Trim control or Volume on the unit! The Phono will be the Pass Labs XP17 which has plenty of gain with .04mv cartridge! Haven't tried yet but am getting different opinions! I saw the previous thread on the Goldpoint so I thought I would ask for your peoples expertise! Thank you
     
  2. jexby

    jexby Posole Prince

    Staff Member Pyrate Contributor
    Joined:
    Sep 28, 2015
    Likes Received:
    8,146
    Trophy Points:
    113
    Location:
    Exit stage left....
    if you are new here you should have first lurked for a bit, then read other threads about where to post for All Purpose Advice and not start short lived Q&A topic.
    hmm?
    ok.
     
  3. purr1n

    purr1n Desire for betterer is endless.

    Staff Member Pyrate BWC
    Joined:
    Sep 24, 2015
    Likes Received:
    89,962
    Trophy Points:
    113
    Location:
    Padre Island CC TX
    answer here: https://www.superbestaudiofriends.o...purpose-advice-thread.19/page-555#post-375715
     
Thread Status:
Not open for further replies.

Share This Page