HD600 and Harmon Target

Discussion in 'Measurement Techniques Discussion' started by Vtory, Feb 24, 2019.

  1. Vtory

    Vtory Audiophileâ„¢

    Pyrate MZR
    Joined:
    Sep 12, 2016
    Likes Received:
    10,831
    Trophy Points:
    113
    Location:
    East Coast
  2. purr1n

    purr1n Desire for betterer is endless.

    Staff Member Pyrate BWC
    Joined:
    Sep 24, 2015
    Likes Received:
    89,771
    Trophy Points:
    113
    Location:
    Padre Island CC TX
  3. TomHP

    TomHP Facebook Friend

    Joined:
    Nov 24, 2016
    Likes Received:
    153
    Trophy Points:
    43
    Location:
    Taiwan
    GRAS 43AG is the same coupler as what was used by Harman, except they used a stereo version (L and R ears in a single unit).

    Different dummy head ears geometry are different leading to small differences in low treble/treble between HATS/KEMAR/HEAD, but if a coupler is IEC compliant (ie. 318/711), the FR and impedance curves are specced within tight tolerances. Plus, they come with individual correction curves typically. So not sure what you're on about...
     
  4. Vtory

    Vtory Audiophileâ„¢

    Pyrate MZR
    Joined:
    Sep 12, 2016
    Likes Received:
    10,831
    Trophy Points:
    113
    Location:
    East Coast
    Thanks for pointing out them. Just tried to overlap several sets of measurements between 43AG and 43CA, and confirmed they were quite consistent, regardless of slightly different pinnae settings. I might have been more careful.
     

Share This Page