Yes it was magnitude vs normalized frequency. I trimmed off the parts below -100 dB because that shouldn't be very audible. I used milliseconds...
Interesting read. ESL isn't my field of strength, but reading this article helped me undestand the ESL systems more. I think our focuses were...
Great call, here's what happens with a typical Stax load: [ATTACH] I plotted inductance here too. There appears to be a resonance at 40 MHz. I...
Put up some code to show the capacitance curves of cables and loads. Hope it'll help visualize what's going on. The estimation I did last night...
If a number has to be picked, the "ideal" damping ratio is usually at 0.707 aka the butterworth response for a 2nd order system. It's the quickest...
I was thinking about this over the past week, but enlightenment didn't hit until I was doing some amp simulation today... The video did great...
I think you're right. Looked up the properties of Ag2S, and it seems to be softer than pure silver and gold. Hmmm maybe I should try coating my...
My concern isn't the silver gets eaten away, but the oxidation hardening effect like aluminum. There's finally a solution for orthos to break up...
Yeah it takes a little strecth, but still quite easy. Most 10cm pads should have no problem mounting on it. It could get a little sweaty in the...
Holy f**k, all the dots just connected in my mind tonight. What Moondrop did in the Para was actual innovation. Kinda like what Fostex did in...
Just did a waterfall plot with miniDSP EARS, probably not as reliable as FPC measurements, but should tell the idea. It look like there's some...
Just got my Para delivered a few hours ago, and liked the drivers quite a lot. I bought it for the sole purpose with its silver traced diaphragm....
I haven't looked into how that part is handled, but this could make sense. It feels like another jar of worms. Bayer sensors does have less...
Hmmm I didn't think about the 88.2 kHz case. Improperly downsamp it to 88.2 kHz would fold some of the aliasing back into audible range, so it...
Yeah I think my thoughts aren't fully flushed out yet. I just saw the blog post yesterday, and trying to draw parallels between them. A large...
Separate names with a comma.