I mean you can have a two way with no electrical crossover on the widebander, hint hint ;P
https://hificompass.com/en/speakers/measurements/bliesma/bliesma-m142a-6
hificompass now has BlieSMa M142 measurements! Dispersion and distortion are the best I've seen!
I know you've heard Voxativs. But you need to hear the treble from my OBs |{ (Then again I know my electronics wouldn't satisfy you) I don't...
No, it is indeed dB SPL, so the values are relative to 20uPa. It's negative simply because in the midrange the SPL I could hear was significantly...
I realized that while I updated the other thread, I felt like I still had to update this one: [ATTACH] Doesn't look very different. The upper...
New project: A new rig for measuring impedances. I used 100W power resistors, gave it 4 channels, 2 XLR and 2 RCA. I used symmetrical power...
LOL, would probably end up being true for me, though. Then again those LLMs already generate way too long texts with lots of disclaimers. But in...
I generally like what SwiftKey does. Of course there's the caveat that you have to give Microsoft your data.
MEASUREMENTS [SPOILER] [SPOILER] [SPOILER] I didn't take measurements at closer distances to get good looking distortion measurements, but the...
Finally did the "XO12" upgrade I've been meaning to do for a while now. XO12 upgrade consists mainly of better caps all around and a slightly...
FWIW the Aegir (even when running two) has a hard time controlling my 85dB sensitive (87dB in the bass) 4 Ohm Hathors. It does go loud enough...
Yes, but looking at it from the excess group delay will require lots of zooming between the lower and higher frequencies. 0.1ms is 360° at 10kHz,...
It's hard to measure in room, but excess phase is far more telling than excess group delay. Hathor cardioid monitor has 0 degrees of excess phase....
I fully expect the 5kHz peak to be a resonance / ridge in the CSDs with resulting overshoot and ringing in the burst response. Does it sound...
Separate names with a comma.