The cans [IMG] The rig [IMG] FR [IMG] TH-X00 dist [IMG] D7000 dist [IMG] Step IR [IMG] TH-X00 decay [IMG] D7000 decay [IMG] TH-X00...
Hi I was wondering if anyone could recommend a free image hosting site/service. I have used some sites in the past that seem to lose the link...
Curious if you ever tried the latex? I dont know about body paint but other paint types do maintain a malleable rubber feel(like #7) after they...
The foam is to minimize interference from other noises like resonance off the plate. They use specific foam to get a better seal as well,...
[IMG] My first measurement rig :D. Cheap & easy mic from ojneg ==> Behringer umc404-hd ==> REW. Been playing with my beyer dt770 while learning...
would soldering point to point instead of using a pcb work the same?
[IMG] is this correct? just wanted to check before I solder them to the board
Threw the akg K551 pads on the T70p, sounds really nice. Brought more life to the low end, sub bass sounds very nice. I cant tell if it helped...
ahhh now i see, thanks
In the first picture of the assembled board there looks to be 2 different resistors but the parts list only mentions 1, am I missing something?
Will a microphone measure differently if it is angled? I am trying to measure headphones with emm6(omnidirectional mic)
the T5p (2nd gen) look like they should have potential, I am also going to test akg k55x pads once I get my t70p.$180 > cost = :D should be here...
[IMG] Got the interface, mics, and cables. Now on to building the mounting system. Couple questions- I have noticed that a lot of the...
I tried my zmf pads(angled lambskin), not mounted properly just pressed on. They did not do the t90 any favors, seemed like it hollowed out the...
Separate names with a comma.